FM-11: Lampu Kerja Tidak Berfungsi Normal

Lampu kerja gelap atau berkedip, atau penundaan setelah pelepasan pemicu tidak normal.

• Battery charge is too low for a valid test
• Trigger is not moving far enough to activate the light
• Lens area is blocked by dry debris
• LED or wiring is damaged
• Switch or electronic control fault

1. The worklight activates with the trigger and turns off after normal delay.

1. Remove the saw from the work and install a charged known-good battery.
2. Operate lock-off and trigger briefly while watching the light.
3. Brush only loose dry debris from the lens area and repeat the no-load timing check.
4. If the light stays dark, flickers, or times incorrectly, use qualified service.

This is a preview of the troubleshooting guidance included in the full repair manual.

• Lampu kerja dan lensa
• Lampu kerja, rumah, atau rel

• Lampu Kerja Tidak Berfungsi Normal

  Lampu kerja gelap atau berkedip, atau penundaan setelah pelepasan pemicu tidak normal.

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

Public pages show a preview only. Purchase the full manual to download complete repair steps, diagrams, and verification procedures.