FM-03: Gergaji Mulai, Kemudian Mati Saat Pemicu Ditekan

Gergaji mulai, lalu berhenti saat pemicu tetap ditekan, baik dalam beban atau tanpa beban.

• Pack protection opened for charge or temperature
• Blade was pinched, bound, or overloaded by the cut
• Pack is loose or the contacts are intermittent under vibration
• Blocked vents or heavy loading caused thermal protection
• Internal control or motor fault

1. The saw runs steadily at no load and through a controlled supported cut.

1. Release the trigger and wait until the blade stops completely.
2. Remove the battery, free the saw from the work, and clear any pinching or blocked vents.
3. Install a charged known-good pack and run the saw briefly at no load.
4. - If no-load cutout repeats, keep the saw out of service - if stable, correct blade, support, and feed.

This is a preview of the troubleshooting guidance included in the full repair manual.

• Motor, gearcase, atau spindle
• Antarmuka battery FLEXVOLT
• module elektronik dan motor
• FLEXVOLT battery kompatibel

• Gergaji Mulai, Kemudian Mati Saat Pemicu Ditekan

  Gergaji mulai, lalu berhenti saat pemicu tetap ditekan, baik dalam beban atau tanpa beban.

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

Public pages show a preview only. Purchase the full manual to download complete repair steps, diagrams, and verification procedures.