FM-10: POTONGAN TIDAK SEGI EMPAT ATAU SUDUT BEVEL TIDAK AKURAT

FM-10 POTONGAN TIDAK SEGI EMPAT ATAU SUDUT BEVEL TIDAK AKURAT

• Blade is loose, warped, or not seated
• Shoe is not square to the blade at zero
• Bevel scale or 90-degree alignment needs calibration
• Shoe is bent or work support is uneven
• Guide technique or blade choice causes wandering

1. A measured scrap cut matches the selected 0-degree or bevel setting and the shoe remains locked.

1. Set the desired bevel from the scale, tighten the bevel knob, set and lock depth, and use a marked line, fence, or straightedge on supported work.
2. Make and measure a scrap cut; if calibration cannot be achieved or the blade wanders with sound setup, service the shoe, spindle, or bearing.
3. Remove the battery, set the bevel to zero, and place a square between the shoe and blade body while avoiding the carbide teeth.
4. Confirm the blade, washer, and bolt are seated and secure, and inspect the shoe for bending; use the manual 90-degree alignment procedure only when needed.

This is a preview of the troubleshooting guidance included in the full repair manual.

• Gergaji menyelesaikan potongan, tetapi potongan 0 derajat tidak segi empat, bevel tidak sesuai skala, atau alur menyimpang dari sudut yang dimaksud.

  Gergaji menyelesaikan potongan, tetapi potongan 0 derajat tidak persegi, 1. Lepaskan battery, atur kemiringan ke nol, dan letakkan penggaris siku di antara sepatu dan

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

Public pages show a preview only. Purchase the full manual to download complete repair steps, diagrams, and verification procedures.