FM-06: MOTOR BERPUTAR TAPI BILAH TIDAK BERPUTAR

FM-06 MOTOR BERPUTAR TAPI BILAH TIDAK BERPUTAR

• Blade bolt or outer washer is loose or assembled wrong
• Blade is not seated on the spindle
• Blade bolt or washer is damaged
• Gear train or spindle has stripped or broken
• Spindle lock damage is interfering with the drive

1. The securely mounted blade follows the spindle immediately and runs without slipping.

1. Inspect blade seating, rotation direction, outer washer, and the left-hand blade bolt; engage the spindle lock only while stopped and tighten the bolt counterclockwise.
2. With the battery removed, rotate the blade gently by hand and verify the spindle turns with it without clamp slip, grinding, or abnormal free play.
3. If the motor runs but the correctly clamped spindle or blade still does not drive, stop testing and have the gear train, spindle, and lock serviced.
4. Release the trigger, wait for all motion to stop, remove the battery, and do not run the saw again until the blade drive is checked.

This is a preview of the troubleshooting guidance included in the full repair manual.

• Motor berputar tapi bilah diam

  Motor berputar tapi bilah diam Kesalahan penjepit bilah, roda gigi, atau penggerak spindel; gunakan FM-06.

• motor terdengar berputar, tetapi bilah tetap diam, mulai terlambat, atau selip alih-alih mengikuti motor.

  motor terdengar berputar, tetapi bilah tetap diam, mulai terlambat, atau meluncur alih-alih mengikuti motor. 1. Lepaskan pelatuk, tunggu hingga semua gerakan berhenti, lepaskan battery, dan jangan jalankan gergaji lagi sampai penggerak bilah diperiksa.

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

Public pages show a preview only. Purchase the full manual to download complete repair steps, diagrams, and verification procedures.