FM-09: GERGAJI MENENDANG BALIK, NAIK, ATAU MELANGKAH MUNDUR

Gergaji menunjukkan perilaku tendangan balik: tiba-tiba terangkat, melompat ke arah operator, naik dari alur potong, atau melangkah mundur karena penjepitan atau puntiran bilah.

• Kerf closes on the blade from poor support
• Blade is dull, damaged, or misaligned
• Saw is twisted or restarted with teeth engaged
• Depth or bevel lock shifted
• Operator is behind the blade line or pulling backward

1. A properly supported test cut tracks forward without pinch, climb, backward motion, or shifting adjustments.

1. Remove the battery and identify the pinch or twist: check panel support, kerf closure, blade condition, blade seating, and tight depth and bevel locks.
2. Correct support on both sides near the cut, set one-tooth depth, fit a sharp correct blade, and center the blade in the kerf before any restart.
3. Make a fresh controlled test with both hands and your body to one side of the blade; repeat kickback means stop use and qualified inspection.
4. Release the trigger and hold the saw motionless in the material until the blade completely stops; never pull the saw backward while the blade moves.

This is a preview of the troubleshooting guidance included in the full repair manual.

• Kenop bevel, skala, pivot, dan penyelarasan 90 derajat

• Gergaji tiba-tiba terangkat, melompat ke arah operator, keluar dari alur, atau berjalan mundur saat bilah mencubit atau berputar.

  Gergaji tiba-tiba terangkat, melompat ke arah operator, keluar dari alur, atau berjalan mundur saat bilah mencubit atau berputar. Lepaskan pelatuk dan tahan gergaji diam di dalam bahan hingga bilah benar-benar berhenti; jangan pernah menarik gergaji mundur saat bilah bergerak.

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

Public pages show a preview only. Purchase the full manual to download complete repair steps, diagrams, and verification procedures.