FM-22: बेवल कोण सेट, लॉक, होल्ड, या सही ढंग से पढ़ा नहीं जाता

जूता इच्छित सीमा के माध्यम से झुकेगा नहीं, बेवल लीवर क्लैंप नहीं करेगा, कट के दौरान कोण फिसलेगा, या पॉइंटर/चतुर्थांश पुनरावृत्त कोण नहीं देगा।

• Sawdust is packed at the pivot, quadrant, pointer, or lever
• Lever is loose, stripped, cracked, or incorrectly positioned
• Shoe, pivot, quadrant, or pointer is bent or worn
• Zero calibration or angle reading is being confused with a general locking failure

1. The shoe sets within its range, locks firmly without movement, and produces a repeatable verified bevel angle.

1. Remove the battery and set the saw on a stable surface before touching the bevel lever or shoe.
2. Clean the exposed pivot, quadrant, pointer, and lever dry, then inspect for cracks, bend, missing hardware, or a lever that cannot clamp.
3. Loosen the lever counterclockwise, tilt the shoe to the desired marked angle within 0-57 degrees, and retighten the lever clockwise firmly.
4. - Check for movement by hand and confirm the angle with a gauge or a controlled scrap cut - use FM-21 only for a zero-degree calibration error.
5. If the shoe cannot move, lock, hold, or read repeatably, keep the saw out of service for authorized lever, pivot, quadrant, pointer, and shoe repair.

This is a preview of the troubleshooting guidance included in the full repair manual.

• बेवेल लीवर, क्वाड्रंट, पॉइंटर, और शून्य कैलिब्रेशन
• शू और संरचनात्मक पिवट्स

• बेवल कोण सेट, लॉक, होल्ड, या सही ढंग से पढ़ा नहीं जाता

  जूता इच्छित सीमा के माध्यम से झुकेगा नहीं, बेवल लीवर क्लैंप नहीं करेगा, कट के दौरान कोण फिसलेगा, या पॉइंटर/चतुर्थांश पुनरावृत्त कोण नहीं देगा।

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

Public pages show a preview only. Purchase the full manual to download complete repair steps, diagrams, and verification procedures.