FM-12: ब्लेड BOLT या स्पिंडल लॉक काम नहीं करता

FM-12 ब्लेड BOLT या स्पिंडल लॉक काम नहीं करता

• Lock is not aligned with the spindle position
• Left-hand bolt is being turned the wrong direction
• Hex recess or wrench is rounded
• Bolt, washer, or spindle threads are dirty or damaged
• Spindle lock mechanism is broken

1. The spindle lock engages only while stopped, the bolt turns in the correct direction, and the blade clamps securely.

1. Clean the bolt, washer, and accessible spindle seating dry and inspect for cross-threading, cracks, burrs, or incorrect hardware.
2. If the lock will not engage or the bolt is seized, stripped, or damaged, do not improvise leverage; have the spindle and hardware serviced.
3. Remove the battery, use the supplied hex wrench, and press the spindle lock while rotating the blade by hand until the lock fully engages.
4. Remember the left-hand thread: turn the blade bolt clockwise to loosen and counterclockwise to tighten; stop if the wrench or recess begins to round.

This is a preview of the troubleshooting guidance included in the full repair manual.

• स्पिंडल लॉक जुड़ता नहीं है, दिया गया रिंच bolt नहीं घुमाता, या ब्लेड bolt जाम, स्ट्रिप्ड, या क्रॉस-थ्रेडेड है।

  स्पिंडल लॉक जुड़ नहीं रहा है, आपूर्ति किया गया रिंच 1. battery को हटा दें, आपूर्ति किया गया हेक्स रिंच का उपयोग करें, और स्पिंडल लॉक दबाएं जबकि

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

Public pages show a preview only. Purchase the full manual to download complete repair steps, diagrams, and verification procedures.