FM-05: सॉ लोड के तहत बंद हो जाती है या कट में चालू-बंद होती है

FM-05 सॉ लोड के तहत बंद हो जाती है या कट में चालू-बंद होती है

• Electronic protection stopped overload, heat, or deep discharge
• Battery latch or contacts are intermittent
• Battery is weak or not fully charged
• Blade is dull, pinched, or set too deep
• Switch, motor, wiring, or gear train is failing

1. The saw maintains steady power through a supported test cut without contact movement, overload shutdown, or intermittent stopping.

1. Inspect for a sharp correct blade, one-tooth depth, tight depth and bevel locks, and work support that keeps the kerf from closing on the blade.
2. Test a known-good battery on supported scrap with gentle feed; if cutouts repeat after load and fit are corrected, stop and service the switch, motor, wiring, or gear train.
3. Release the trigger, hold the saw still until the blade stops, remove the battery, and let both tool and pack cool before inspection.
4. Check the battery latch and contacts, clear the cooling vents dry, and fully charge the battery; use FM-15 for a pack that moves or will not latch.

This is a preview of the troubleshooting guidance included in the full repair manual.

• Saw cuts out under load

  Saw cuts out under load Electronic protection, weak pack, intermittent contact, overload, or internal fault; use FM-05.

• The saw starts normally but stops, pulses, or loses power during a cut, especially when pushed or when the battery is moved.

  The saw starts normally but stops, pulses, or loses power 1. Release the trigger, hold the saw still until the blade stops, remove the battery, and let

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

Public pages show a preview only. Purchase the full manual to download complete repair steps, diagrams, and verification procedures.