FM-06: टूल या BATTERY हिलाने पर पावर कट जाता है

गतिविधि-निर्भर पावर कटआउट।

• Dry contamination, wear, or damage at the battery contacts
• Battery shell or latches allow electrical movement despite physical retention
• Tool contact block or internal wiring is loose
• Trigger, direction switch, brush, or motor connection is intermittent

1. Ordinary handling no longer interrupts power, or the internal intermittent path is conclusively routed to service.

1. Repeat with a known-good compatible battery to separate a pack-side intermittent condition from the tool-side path.
2. With the chuck empty, make one brief no-load test while changing only normal hand orientation; do not flex, strike, shim, or hold the pack in place.
3. If a proven battery still causes cutout with ordinary movement, remove it and route the contact block, wiring, switch, brush, or motor path to service.
4. Release the trigger and remove the battery before inspecting the contacts, latches, stem, and tool rail path for heat, burning, looseness, or impact damage.
5. Dry-clean the accessible contacts and latch surfaces, then install the original pack until the release latch pass an unpowered pull test.

This is a preview of the troubleshooting guidance included in the full repair manual.

• battery भौतिक रूप से लैच रहता है, लेकिन motor, एलईडी, या दोनों कट जाते हैं और टूल या battery को सामान्य कार्यशील स्थिति में हिलाने पर वापस आते हैं।

  battery भौतिक रूप से लॉक रहता है, लेकिन motor, LED, या 1. ट्रिगर छोड़ें और संपर्कों का निरीक्षण करने से पहले battery निकालें,

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

Public pages show a preview only. Purchase the full manual to download complete repair steps, diagrams, and verification procedures.