La scie coupe lentement, semble faible, brûle le bois ou laisse une coupe rugueuse

La lame atteint une vitesse normale stable à vide, mais la coupe est anormalement lente, nécessite une alimentation lourde, brûle le bois ou produit un éclatement excessif sans calage complet.

• Blade is dull, dirty, wrong tooth count, installed backward, or unsuitable for the wood
• Depth is excessive or bevel/depth levers are not secured
• Feed is too fast, material is wet/dense, or the shoe is not flat
• Battery capacity is low or internal drive drag appears only under load

1. A sharp correct blade makes a controlled cut at normal feed with no burning, excessive splintering, laboring, or unusual battery heat.

1. Release the trigger, wait for a full stop, remove the battery, and inspect the cut rather than increasing force.
2. - Verify blade type, tooth condition, rotation direction, clean clamp stack, and secure mounting - replace a dull, dirty, damaged, or unsuitable blade.
3. Set depth to about one-half tooth below the material, lock depth and bevel, support the work, keep the shoe flat, and use an unforced feed rate.
4. - Compare one cut using a known-good fully charged compatible pack - if normal no-load speed remains but cutting stays weak with a correct sharp blade and set

Ceci est un aperçu des conseils de dépannage inclus dans le manuel de réparation complet.

• FM-19: Fm Dcs578 19

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

Les pages publiques n'affichent qu'un aperçu. Achetez le manuel complet pour télécharger les étapes de réparation, schémas et procédures de vérification complets.