Le Battery ne s'installe pas, ne se verrouille pas ou ne se libère pas de la scie

Un pack apparemment compatible ne glisse pas complètement sur les rails, ne reste pas verrouillé ou ne se libère pas lorsque le bouton de déverrouillage est pressé.

• Pack is misaligned, incompatible, swollen, or damaged
• Sawdust or a bent rail is obstructing travel
• Battery release button or latch is jammed, cracked, or not returning
• Handle rails or battery-interface housing are damaged

1. The pack slides on without force, clicks securely, cannot disengage unintentionally, and releases normally when the button is pressed.

1. Place the saw on a stable side surface, release the trigger, and do not force, hammer, or pry the pack.
2. Inspect the pack case, rails, latch, release button, and saw rails for debris, swelling, cracks, heat damage, or bent plastic.
3. Clean the rails dry, align the pack squarely, slide until it latches, or press the release fully and pull the pack straight out.
4. - Compare with a known-good compatible pack - if the tool rails, latch, release, or housing remain damaged or jammed, keep the saw out of service for authoriz

Ceci est un aperçu des conseils de dépannage inclus dans le manuel de réparation complet.

• FM-04: Fm Dcs578 04

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

Les pages publiques n'affichent qu'un aperçu. Achetez le manuel complet pour télécharger les étapes de réparation, schémas et procédures de vérification complets.