La lame installée est lâche, oscille, glisse ou tourne hors centre

Après installation, la lame peut bouger sur la broche, oscille visiblement de côté, glisse sous charge ou ne reste pas centrée même si le motor tourne.

• Wrong arbor size, blade diameter, blade type, or damaged blade plate
• Outer washer is reversed, missing, dirty, or not seated
• Clamping screw is loose or clamp/spindle surfaces are damaged
• Blade is bent, cracked, or mounted in the wrong rotation direction

1. With the battery removed, the blade is rigid at the spindle, rotates by hand without lateral runout or guard contact, and remains secure in one controlled cut.

1. Release the trigger at the first wobble or slip, wait for a full stop, remove the battery, and do not make another powered cut.
2. Remove the blade and reject any bent, cracked, chipped, wrong-size, wrong-arbor, abrasive, or unsuitable blade.
3. Clean the spindle and clamp area dry, inspect both washers and the clamping screw, and confirm the large flat washer face is against the blade with the bev
4. Install a verified correct blade in the marked rotation direction and tighten firmly using the blade-lock and wrench procedure.
5. - Hand-turn and visually check clearance and runout - if looseness, slip, or off-center rotation remains, stop and route the spindle/clamp system for authoriz

Ceci est un aperçu des conseils de dépannage inclus dans le manuel de réparation complet.

• FM-16: Fm Dcs578 16

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

Les pages publiques n'affichent qu'un aperçu. Achetez le manuel complet pour télécharger les étapes de réparation, schémas et procédures de vérification complets.