La scie ou le carter d'engrenage devient anormalement chaud ou dégage une odeur de chaud sans fumée ni étincelles

Le boîtier, le carter d'engrenage, l'interface battery ou la zone motor chauffe anormalement vite ou dégage une odeur mécanique/électrique de chaud, mais il n'y a pas de fumée visible, d'étincelle, de fusion ou de liquide.

• Vents are blocked by sawdust or the saw is being forced
• Dull, dirty, wrong, or deeply set blade is overloading the motor
• Blade, guard, bearing, or gear drive is dragging
• Battery, motor, electronic module, bearing, or gearcase is failing

1. After correction, one controlled light cut produces normal temperature rise only, with free blade/guard movement and no hot odor.

1. Release the trigger, keep control until the blade stops and guard closes, remove the battery, and let the saw cool in a dry noncombustible area.
2. - Inspect for smoke, sparks, melting, liquid, battery damage, or worsening odor - route those conditions immediately to FM-06 or FM-14.
3. Clean the vents with dry air, correct blade depth and work support, and replace any dull, dirty, damaged, or wrong blade.
4. With the battery removed, hand-turn the blade and check the lower guard for free motion without scrape or drag.
5. - Use a known-good pack for one light supported scrap cut - if rapid heat or hot odor returns, stop and request authorized motor, electronic, bearing, and gea

Ceci est un aperçu des conseils de dépannage inclus dans le manuel de réparation complet.

• FM-13: Fm Dcs578 13

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

Les pages publiques n'affichent qu'un aperçu. Achetez le manuel complet pour télécharger les étapes de réparation, schémas et procédures de vérification complets.