La lampe de travail ne fonctionne pas, scintille ou reste allumée bien au-delà de son délai normal

Le motor fonctionne normalement, mais la lampe de travail intégrée ne s'allume pas, scintille avec un battery stable ou reste allumée beaucoup plus longtemps que le délai normal après la gâchette.

• Worklight lens or opening is packed with sawdust
• Battery or trigger input is intermittent
• LED, light wiring, or electronic timing control has failed
• Normal delay of about 20 seconds is being mistaken for a fault

1. The worklight illuminates steadily with trigger operation and turns off automatically after its normal delay.

1. - Confirm the motor operates normally and time the light only after the trigger is fully released - a delay of about 20 seconds is normal.
2. Remove the battery and clean the light opening and surrounding external area with a dry brush or clean dry air.
3. Install a known-good fully charged compatible pack and repeat a brief no-load trigger-and-release check.
4. If the motor remains normal but the light still fails, flickers, or remains on abnormally, leave the housing closed and request authorized light or control

Ceci est un aperçu des conseils de dépannage inclus dans le manuel de réparation complet.

• FM-12: Fm Dcs578 12

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

Les pages publiques n'affichent qu'un aperçu. Achetez le manuel complet pour télécharger les étapes de réparation, schémas et procédures de vérification complets.