La scie est complètement morte - Pas de lumière de travail et aucune réponse de Motor

Un battery apparemment chargé est installé et la gâchette est actionnée, mais la lumière de travail ne s'allume jamais et la lame ne bouge pas.

• FLEXVOLT battery is discharged, protected, damaged, or not fully seated
• Battery rails or accessible contacts are dirty, wet, burned, or damaged
• Trigger lock-off is not being released
• Trigger switch, electronic module, motor, or internal power path has failed

1. With a proven pack installed, the worklight responds to trigger operation and the blade reaches normal no-load speed.

1. Set the saw on its side with the trigger released, remove the battery, and keep the blade clear of people and material.
2. - Inspect the pack, rails, latch, and accessible contacts for cracks, swelling, liquid, scorching, unusual heat, or debris - route any battery hazard to FM-06
3. Charge the pack with its designated charger, clean only dry accessible interfaces, and install a known-good fully charged compatible FLEXVOLT pack until it
4. - Press the lock-off deliberately and pull the trigger once with the blade clear of all material - if the worklight and motor both remain absent, keep the hou

Ceci est un aperçu des conseils de dépannage inclus dans le manuel de réparation complet.

• FM-01: Fm Dcs578 01

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

Les pages publiques n'affichent qu'un aperçu. Achetez le manuel complet pour télécharger les étapes de réparation, schémas et procédures de vérification complets.