Le verrou de lame ou le matériel de serrage ne permet pas de retirer ou de sécuriser la lame

Le verrou de lame ne s'engage pas ou ne se libère pas, le screw de serrage ne tourne pas correctement, ou le screw et la rondelle extérieure ne peuvent pas sécuriser une lame lors de l'installation.

• Blade lock button is jammed, damaged, or being used incorrectly
• Clamping screw threads, wrench flats, spindle, or outer washer are damaged
• Sawdust or corrosion is packed in the clamp area

1. The blade lock engages only during hand rotation, the correct screw turns in the proper direction, the washer seats correctly, and the blade clamps firmly.

1. Remove the battery, set the saw on its side, and never press the blade lock while the saw is powered or use it as a brake.
2. - Hand-turn the spindle while pressing the blade lock until it engages - use the blade wrench and remember the right-hand screw loosens counterclockwise and t
3. - Remove only the clamping screw and outer washer, clean sawdust dry, and inspect the lock, screw, washer, spindle threads, and wrench flats for damage - do n
4. Reassemble with the large flat face of the outer washer against the blade and the beveled side out, then tighten the screw firmly by the official sequence.
5. If the lock will not engage/release or any clamp or spindle surface is stripped, cracked, rounded, or unable to hold torque, keep the battery out and use a

Ceci est un aperçu des conseils de dépannage inclus dans le manuel de réparation complet.

• FM-15: Fm Dcs578 15

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

Les pages publiques n'affichent qu'un aperçu. Achetez le manuel complet pour télécharger les étapes de réparation, schémas et procédures de vérification complets.