failure mode
FM-03: La scie démarre, puis s'arrête avec la gâchette maintenue
La scie démarre, puis s'arrête alors que la gâchette reste maintenue, en charge ou à vide.
Aperçu diagnostique
La scie démarre, puis s'arrête alors que la gâchette reste maintenue, en charge ou à vide.
Causes probables
- Pack protection opened for charge or temperature
- Blade was pinched, bound, or overloaded by the cut
- Pack is loose or the contacts are intermittent under vibration
- Blocked vents or heavy loading caused thermal protection
- Internal control or motor fault
Vérifications rapides
- The saw runs steadily at no load and through a controlled supported cut.
Aperçu de réparation
- Release the trigger and wait until the blade stops completely.
- Remove the battery, free the saw from the work, and clear any pinching or blocked vents.
- Install a charged known-good pack and run the saw briefly at no load.
- - If no-load cutout repeats, keep the saw out of service - if stable, correct blade, support, and feed.
Ceci est un aperçu des conseils de dépannage inclus dans le manuel de réparation complet.
Réparations courantes
- Motor, carter d'engrenage ou broche
- Interface de pack FLEXVOLT battery
- Module électronique module et motor
- battery FLEXVOLT compatible
Symptômes associés
La scie démarre, puis s'arrête avec la gâchette maintenue
La scie démarre, puis s'arrête alors que la gâchette reste maintenue, en charge ou à vide.
Inclus dans le manuel complet
- root cause analysis
- tools needed
- step-by-step repair procedure
- diagrams
- exploded views
- post-repair checks
Les pages publiques n'affichent qu'un aperçu. Achetez le manuel complet pour télécharger les étapes de réparation, schémas et procédures de vérification complets.