failure mode
FM-03: La Sierra Arranca Y Luego Se Apaga Con El Gatillo Presionado
La sierra arranca y luego se detiene mientras el gatillo permanece presionado, con carga o sin carga.
Resumen de diagnóstico
La sierra arranca y luego se detiene mientras el gatillo permanece presionado, con carga o sin carga.
Causas probables
- Pack protection opened for charge or temperature
- Blade was pinched, bound, or overloaded by the cut
- Pack is loose or the contacts are intermittent under vibration
- Blocked vents or heavy loading caused thermal protection
- Internal control or motor fault
Comprobaciones rápidas
- The saw runs steadily at no load and through a controlled supported cut.
Vista previa de reparación
- Release the trigger and wait until the blade stops completely.
- Remove the battery, free the saw from the work, and clear any pinching or blocked vents.
- Install a charged known-good pack and run the saw briefly at no load.
- - If no-load cutout repeats, keep the saw out of service - if stable, correct blade, support, and feed.
Esta es una vista previa de la guía de solución de problemas incluida en el manual de reparación completo.
Soluciones habituales
- Motor, caja de engranajes o eje
- Interfaz de paquete FLEXVOLT battery
- module electrónico y motor
- battery FLEXVOLT compatible
Síntomas relacionados
La Sierra Arranca Y Luego Se Apaga Con El Gatillo Presionado
La sierra arranca y luego se detiene mientras el gatillo permanece presionado, con carga o sin carga.
Incluido en el manual completo
- root cause analysis
- tools needed
- step-by-step repair procedure
- diagrams
- exploded views
- post-repair checks
Las páginas públicas muestran solo una vista previa. Compra el manual completo para descargar los pasos de reparación, diagramas y procedimientos de verificación completos.