FM-10: EL CORTE NO ES RECTO O EL ÁNGULO DE BISEL ES INEXACTO

FM-10 EL CORTE NO ES RECTO O EL ÁNGULO DE BISEL ES INEXACTO

• Blade is loose, warped, or not seated
• Shoe is not square to the blade at zero
• Bevel scale or 90-degree alignment needs calibration
• Shoe is bent or work support is uneven
• Guide technique or blade choice causes wandering

1. A measured scrap cut matches the selected 0-degree or bevel setting and the shoe remains locked.

1. Set the desired bevel from the scale, tighten the bevel knob, set and lock depth, and use a marked line, fence, or straightedge on supported work.
2. Make and measure a scrap cut; if calibration cannot be achieved or the blade wanders with sound setup, service the shoe, spindle, or bearing.
3. Remove the battery, set the bevel to zero, and place a square between the shoe and blade body while avoiding the carbide teeth.
4. Confirm the blade, washer, and bolt are seated and secure, and inspect the shoe for bending; use the manual 90-degree alignment procedure only when needed.

Esta es una vista previa de la guía de solución de problemas incluida en el manual de reparación completo.

• La sierra completa el corte, pero un corte a 0 grados no es recto, el bisel no coincide con la escala o la ranura se desvía del ángulo previsto.

  La sierra completa el corte, pero un corte a 0 grados no es cuadrado, 1. Retire la battery, ajuste el bisel a cero y coloque una escuadra entre la base y

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

Las páginas públicas muestran solo una vista previa. Compra el manual completo para descargar los pasos de reparación, diagramas y procedimientos de verificación completos.