FM-05: LA SIERRA SE APAGA O CORTA INTERMITENTEMENTE BAJO CARGA

FM-05 LA SIERRA SE APAGA O CORTA INTERMITENTEMENTE BAJO CARGA

• Electronic protection stopped overload, heat, or deep discharge
• Battery latch or contacts are intermittent
• Battery is weak or not fully charged
• Blade is dull, pinched, or set too deep
• Switch, motor, wiring, or gear train is failing

1. The saw maintains steady power through a supported test cut without contact movement, overload shutdown, or intermittent stopping.

1. Inspect for a sharp correct blade, one-tooth depth, tight depth and bevel locks, and work support that keeps the kerf from closing on the blade.
2. Test a known-good battery on supported scrap with gentle feed; if cutouts repeat after load and fit are corrected, stop and service the switch, motor, wiring, or gear train.
3. Release the trigger, hold the saw still until the blade stops, remove the battery, and let both tool and pack cool before inspection.
4. Check the battery latch and contacts, clear the cooling vents dry, and fully charge the battery; use FM-15 for a pack that moves or will not latch.

Esta es una vista previa de la guía de solución de problemas incluida en el manual de reparación completo.

• La sierra se apaga bajo carga

  La sierra se apaga bajo carga Protección electrónica, paquete débil, contacto intermitente, sobrecarga o falla interna; use FM-05.

• La sierra arranca normalmente pero se detiene, pulsa o pierde potencia durante un corte, especialmente al empujar o mover el battery.

  La sierra arranca normalmente pero se detiene, pulsa o pierde potencia durante un corte, especialmente cuando se empuja o cuando se mueve el battery.

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

Las páginas públicas muestran solo una vista previa. Compra el manual completo para descargar los pasos de reparación, diagramas y procedimientos de verificación completos.