Hældningsindstilling eller 90 graders skærenøjagtighed er forkert

Skråningshåndtaget låser ikke, kvadrantindstillingen bevæger sig, eller et snit er ikke vinkelret, når markøren er på nul.

• Bevel lever is not fully tightened
• Sawdust blocks the quadrant or shoe pivot
• Pointer or calibration stop is out of adjustment
• Shoe, quadrant, or pivot is bent from impact
• Blade or spindle runout is creating a false angle

1. The lever holds, the zero setting is square, and a scrap cut verifies the angle.

1. Remove the battery, set the bevel to zero, and place the saw on its blade side.
2. Brush the quadrant and pivot, then confirm the lever clamps firmly through the range.
3. Check blade-to-shoe squareness with a square and verify the kerf indicator on scrap.
4. If adjustment will not hold or structure is bent, stop and use qualified service.

Dette er en forhåndsvisning af fejlfindingvejledningen, der er inkluderet i den fulde reparationsmanual.

• FM-13: Fm Dcs575 13

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

Offentlige sider viser kun en forhåndsvisning. Køb den fulde manual for at downloade komplette reparationstrin, diagrammer og verifikationsprocedurer.