Dybdejusteringen vil ikke indstilles, låses eller holde

Foden vil ikke indstille eller klemme dybden, eller skæredybden ændres under brug.

• Depth lever is not fully loosened or tightened
• Sawdust is packed in the shoe slide or pivot
• Depth scale, lever, pivot, or shoe is bent or damaged
• Fastener or clamping surface is worn or loose
• Internal or structural adjustment repair is required

1. The selected depth stays fixed through a supported test cut.

1. Remove the battery, place the saw on a stable surface, and loosen the depth lever.
2. Brush the slide dry and move the shoe through its full range.
3. Set depth so about one-half tooth projects below the workpiece, then tighten the lever firmly.
4. - Push-test and make a scrap cut - if depth moves or the lever will not lock, seek service.

Dette er en forhåndsvisning af fejlfindingvejledningen, der er inkluderet i den fulde reparationsmanual.

• FM-10: Fm Dcs575 10

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

Offentlige sider viser kun en forhåndsvisning. Køb den fulde manual for at downloade komplette reparationstrin, diagrammer og verifikationsprocedurer.