Saven starter, men afbryder med aftrækkeren holdt

Saven starter, men stopper, mens aftrækkeren holdes, under belastning eller uden belastning.

• Pack protection opened for charge or temperature
• Blade was pinched, bound, or overloaded by the cut
• Pack is loose or the contacts are intermittent under vibration
• Blocked vents or heavy loading caused thermal protection
• Internal control or motor fault

1. The saw runs steadily at no load and through a controlled supported cut.

1. Release the trigger and wait until the blade stops completely.
2. Remove the battery, free the saw from the work, and clear any pinching or blocked vents.
3. Install a charged known-good pack and run the saw briefly at no load.
4. - If no-load cutout repeats, keep the saw out of service - if stable, correct blade, support, and feed.

Dette er en forhåndsvisning af fejlfindingvejledningen, der er inkluderet i den fulde reparationsmanual.

• FM-03: Fm Dcs575 03

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

Offentlige sider viser kun en forhåndsvisning. Køb den fulde manual for at downloade komplette reparationstrin, diagrammer og verifikationsprocedurer.