FM-14: Saven eller Battery overopheder eller varmeafbrydelse gentages

Saven eller pakken bliver unormalt varm, mister effekt eller stopper under et understøttet snit.

• Vents are blocked by sawdust or the saw is covered
• Blade is dull or the feed load is excessive
• Battery is hot, cold, low, damaged, or unsuitable
• Cut depth, support, or material is overloading the saw
• Motor, bearing, controller, or battery fault

1. A light supported cut completes without abnormal heat or shutdown.

1. Release trigger, remove pack, and place both on a clear surface.
2. Let saw and pack cool naturally, then brush the vents and inspect for damage or odor.
3. - Fit sharp blade and good pack - correct depth and support - test lightly.
4. If abnormal heat or shutdown returns, stop use and seek qualified service.

Dette er en forhåndsvisning af fejlfindingvejledningen, der er inkluderet i den fulde reparationsmanual.

• Håndtag, hus, ventilationsåbninger
• FLEXVOLT battery interface
• Kompatibel FLEXVOLT battery
• Elektronisk module og motor
• Motor, gearkasse eller spindel

• Saven eller Battery overopheder eller varmeafbrydelse gentages

  Saven eller pakken bliver unormalt varm, mister effekt eller stopper under et understøttet snit.

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

Offentlige sider viser kun en forhåndsvisning. Køb den fulde manual for at downloade komplette reparationstrin, diagrammer og verifikationsprocedurer.