FM-12: Klingen sidder fast, staller eller saven slår tilbage

Klingen klemmer, standser i snittet, klatrer eller hopper, eller kan ikke genstartes sikkert.

• Workpiece support lets the kerf close on the blade
• Blade is dull, damaged, dirty, or installed incorrectly
• Depth or bevel lever is loose or set incorrectly
• Saw is twisted, forced, or restarted in the kerf
• Fastener, knot, or offcut pinches the blade

1. The saw completes a supported cut without binding, stalling, or kickback.

1. Release the trigger and hold the saw still in the kerf.
2. Wait for a complete stop, remove the battery, then free and support the workpiece correctly.
3. Check blade condition, direction, depth, bevel locks, and the cut path for obstructions.
4. Restart only with the blade centered and teeth clear, then verify a controlled supported cut.

Dette er en forhåndsvisning af fejlfindingvejledningen, der er inkluderet i den fulde reparationsmanual.

• Skråningshåndtag og kvadrant
• Kerf-guide og ripladespor
• Dybdehåndtag og fod
• Dybde-, skrånings- eller skosamling
• Cirkelsavklinge

• Klingen sidder fast, staller eller saven slår tilbage

  Klingen klemmer, standser i snittet, klatrer eller hopper, eller kan ikke genstartes sikkert.

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

Offentlige sider viser kun en forhåndsvisning. Køb den fulde manual for at downloade komplette reparationstrin, diagrammer og verifikationsprocedurer.