FM-06: MOTOR KØRER MEN KLINGEN DREJER IKKE

FM-06 MOTOR KØRER MEN KLINGEN DREJER IKKE

• Blade bolt or outer washer is loose or assembled wrong
• Blade is not seated on the spindle
• Blade bolt or washer is damaged
• Gear train or spindle has stripped or broken
• Spindle lock damage is interfering with the drive

1. The securely mounted blade follows the spindle immediately and runs without slipping.

1. Inspect blade seating, rotation direction, outer washer, and the left-hand blade bolt; engage the spindle lock only while stopped and tighten the bolt counterclockwise.
2. With the battery removed, rotate the blade gently by hand and verify the spindle turns with it without clamp slip, grinding, or abnormal free play.
3. If the motor runs but the correctly clamped spindle or blade still does not drive, stop testing and have the gear train, spindle, and lock serviced.
4. Release the trigger, wait for all motion to stop, remove the battery, and do not run the saw again until the blade drive is checked.

Dette er en forhåndsvisning af fejlfindingvejledningen, der er inkluderet i den fulde reparationsmanual.

• Motor kører, men klingen står stille

  Motor kører, men klingen står stille Klingeklemme, gear eller spindeldrevfejl; brug FM-06.

• motor kan høres køre, men klingen forbliver stille, starter sent eller glider i stedet for at følge motor.

  motor kan høres køre, men klingen forbliver stille,

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

Offentlige sider viser kun en forhåndsvisning. Køb den fulde manual for at downloade komplette reparationstrin, diagrammer og verifikationsprocedurer.