FM-09: SAVEN SLÅR TILBAGE, KLATRER ELLER GÅR BAGUD

Saven udviser tilbageslagsadfærd: den løfter pludseligt, springer mod operatøren, klatrer ud af snittet eller går baglæns på grund af klinge-klemning eller vridning.

• Kerf closes on the blade from poor support
• Blade is dull, damaged, or misaligned
• Saw is twisted or restarted with teeth engaged
• Depth or bevel lock shifted
• Operator is behind the blade line or pulling backward

1. A properly supported test cut tracks forward without pinch, climb, backward motion, or shifting adjustments.

1. Remove the battery and identify the pinch or twist: check panel support, kerf closure, blade condition, blade seating, and tight depth and bevel locks.
2. Correct support on both sides near the cut, set one-tooth depth, fit a sharp correct blade, and center the blade in the kerf before any restart.
3. Make a fresh controlled test with both hands and your body to one side of the blade; repeat kickback means stop use and qualified inspection.
4. Release the trigger and hold the saw motionless in the material until the blade completely stops; never pull the saw backward while the blade moves.

Dette er en forhåndsvisning af fejlfindingvejledningen, der er inkluderet i den fulde reparationsmanual.

• Skråningsknap, skala, hængsel og 90-graders justering

• Saven løfter pludseligt, springer mod operatøren, klatrer ud af snittet eller går baglæns, mens klingen klemmer eller vrider.

  Slip aftrækkeren, hold saven stille, indtil klingen stopper, fjern den først efter stop, og fjern {PART_NAME:0}.

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

Offentlige sider viser kun en forhåndsvisning. Køb den fulde manual for at downloade komplette reparationstrin, diagrammer og verifikationsprocedurer.