FM-20: KOBLINGEN FRIGIVES ALDRIG OG OVERDRIVER FASTGØRERE VED LAVE INDSTILLINGER

FM-20

• Collar is actually in drill mode or a high setting
• Fastener, bit, or scrap material is unsuitable for the comparison
• Clutch cam, spring, or detent is jammed
• Gearbox or spindle bypasses the torque-limiting mechanism

1. The clutch ratchets before overdriving at an appropriate low setting, or the no-release fault is proven.

1. Install a verified battery and drive slowly while holding the tool straight, stopping immediately if the fastener begins to overdrive without ratcheting.
2. If several low settings never release under a valid comparison, remove the battery and route the clutch and gearbox to service.
3. Remove the battery and set up a matching fastener and sound driver bit in suitable scrap material.
4. Set the collar to a low numbered position, use range 1, and confirm the index is not on drill mode.

Dette er en forhåndsvisning af fejlfindingvejledningen, der er inkluderet i den fulde reparationsmanual.

• Kraven bevæger sig og holder en lav nummereret indstilling, men koblingen klikker ikke, før en testskrue overstrammes i egnet skrotmateriale.

  Kraven bevæger sig og holder en lav nummereret indstilling, men 1. Fjern battery og forbered en matchende fastgører og lyddriverbit i

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

Offentlige sider viser kun en forhåndsvisning. Køb den fulde manual for at downloade komplette reparationstrin, diagrammer og verifikationsprocedurer.