FM-28: BORING ELLER FASTGØRELSE ER LANGSOM TRODS NORMAL TOMGANGSOPERATION

FM-28

• Bit is dull, wrong for the material, or mismatched to the fastener
• Speed range or clutch setting is wrong for the task
• Work is unsupported, pressure is misdirected, or chips are not clearing
• Battery has reduced capacity under work load
• Internal torque output is reduced without obvious no-load loss

1. The corrected task progresses at normal speed, or the bit, battery, setup, or internal output source is conclusively separated.

1. Remove the battery and inspect or replace the bit before changing any tool setting.
2. Remove the battery and inspect or replace the bit before changing settings FM-28

Dette er en forhåndsvisning af fejlfindingvejledningen, der er inkluderet i den fulde reparationsmanual.

• Boremaskinen lyder og roterer normalt uden belastning, går ikke i stå, overopheder, glider eller vibrerer unormalt, men en korrigeret bore- eller fastgørelsesopgave skrider meget langsommere frem end forventet.

  Boret lyder og roterer normalt uden belastning, går ikke i stå, overopheder, glider eller vibrerer unormalt, men en bore- eller fastgørelsesopgave skrider meget langsommere frem end forventet.

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

Offentlige sider viser kun en forhåndsvisning. Køb den fulde manual for at downloade komplette reparationstrin, diagrammer og verifikationsprocedurer.