FM-02: BATTERY VIL IKKE GLIDE FULDT IND I VÆRKTØJETS SKINNER

inspektion.

• Debris or a raised edge blocks a rail or contact channel
• Battery is misaligned or is not a compatible V20 interface
• Battery shell or tool rail support is swollen, cracked, or distorted
• Release latch or contact block is damaged and out of position

1. A compatible battery slides smoothly to the latched position, or the damaged insertion path remains out of service.

1. Dry-clean both rail paths and accessible contacts, then inspect the battery shell and tool foot for burrs, swelling, cracks, melting, or misalignment.
2. Approach the rails straight with a known-good compatible V20 battery and confirm whether it reaches the latch position smoothly.
3. If two sound packs bind at the same point, keep the tool unpowered and route the rail support, contact block, or housing damage to qualified service.
4. Stop pushing and withdraw the binding battery straight off the rails without twisting, striking, or levering it.

Dette er en forhåndsvisning af fejlfindingvejledningen, der er inkluderet i den fulde reparationsmanual.

• En kompatibel V20 battery starter på værktøjets skinner, men binder, før den når den normale isatte og låste position.

  Et kompatibelt V20 battery starter på værktøjsbanerne, men klemmer 1. Stop med at skubbe og træk den fastklemte battery lige af skinnerne uden

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

Offentlige sider viser kun en forhåndsvisning. Køb den fulde manual for at downloade komplette reparationstrin, diagrammer og verifikationsprocedurer.