failure mode
FM-22 BIT BINDS, TOOL STALLS, TWISTS, OR STOPS IN THE WORK
The accessory bit binds, causing the tool to stall, twist sharply, or stop unexpectedly in the work.
Diagnostisk oversigt
The accessory bit binds, causing the tool to stall, twist sharply, or stop unexpectedly in the work.
Sandsynlige grundårsager
- Bit or fastener is damaged, dull, or wrong for the task
- Tool is off-axis or the work is not secured
- Pilot hole or clearance is inadequate
- Load exceeds the tool, battery, or accessory capability
Hurtige tjek
- The correct accessory drives straight without binding, stalling, or uncontrolled reaction.
Reparationsforhåndsvisning
1.
Dette er en forhåndsvisning af fejlfindingvejledningen, der er inkluderet i den fulde reparationsmanual.
Relaterede symptomer
The accessory catches or stops in the material and the tool reacts sharply in the hand.
The accessory catches or stops in the material and the 1. Release the trigger and control the tool until all motion stops.
Inkluderet i den fulde manual
- root cause analysis
- tools needed
- step-by-step repair procedure
- diagrams
- exploded views
- post-repair checks
Offentlige sider viser kun en forhåndsvisning. Køb den fulde manual for at downloade komplette reparationstrin, diagrammer og verifikationsprocedurer.