FM-07: الشفرة تهتز، تحتك، تهتز، أو تصدر صوت طحن

اهتزازات، احتكاك، اهتزاز، أو طحن شفرة FM-07

• Blade is bent, cracked, chipped, or wrong bore
• Blade, washer, or bolt is dirty or misassembled
• Blade bolt is loose
• Shoe or guard is bent into the blade path
• Spindle or bearing has side play or damage

1. A correct blade runs true, clears the guard and shoe, and produces no abnormal vibration or grinding.

1. Remove and reinstall the blade in the correct direction with clean mating surfaces, the correct outer washer, and the blade bolt securely tightened.
2. Rotate the blade by hand with the battery out and check for side rub, guard contact, a bent shoe, or spindle side play through a full revolution.
3. Perform a brief clear no-load test only if the hand check is normal; persistent wobble, grinding, or side play requires authorized spindle or bearing service.
4. Remove the battery, place the saw on a stable surface, and inspect the blade for bending, cracks, missing tips, wrong bore, or other damage; replace any suspect blade.

هذه معاينة لإرشادات استكشاف الأخطاء وإصلاحها المشمولة في دليل الإصلاح الكامل.

• شفرة منشار دائرية لقطع الخشب

• The blade runs off-center, touches the guard or shoe, produces unusual vibration, or makes a grinding sound.

  The blade runs off-center, touches the guard or shoe, produces 1. Remove the battery, place the saw on a stable surface, and inspect the blade for

• Blade wobbles or grinds

  Blade wobbles or grinds Blade setup, damage, shoe or guard contact, spindle, or bearing fault; use FM-07.

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

تعرض الصفحات العامة معاينة فقط. اشترِ الدليل الكامل لتنزيل خطوات الإصلاح الكاملة والمخططات وإجراءات التحقق.