FM-09: يرتد المنشار، يتسلق، أو يتحرك للخلف

يظهر المنشار سلوك الارتداد: يرفع فجأة، يقفز نحو المشغل، يتسلق خارج الفتحة، أو يتحرك للخلف بسبب انضغاط أو التواء الشفرة.

• Kerf closes on the blade from poor support
• Blade is dull, damaged, or misaligned
• Saw is twisted or restarted with teeth engaged
• Depth or bevel lock shifted
• Operator is behind the blade line or pulling backward

1. A properly supported test cut tracks forward without pinch, climb, backward motion, or shifting adjustments.

1. Remove the battery and identify the pinch or twist: check panel support, kerf closure, blade condition, blade seating, and tight depth and bevel locks.
2. Correct support on both sides near the cut, set one-tooth depth, fit a sharp correct blade, and center the blade in the kerf before any restart.
3. Make a fresh controlled test with both hands and your body to one side of the blade; repeat kickback means stop use and qualified inspection.
4. Release the trigger and hold the saw motionless in the material until the blade completely stops; never pull the saw backward while the blade moves.

هذه معاينة لإرشادات استكشاف الأخطاء وإصلاحها المشمولة في دليل الإصلاح الكامل.

• مقبض الميل، المقياس، المحور، ومحاذاة 90 درجة

• The saw suddenly lifts, jumps toward the operator, climbs out of the kerf, or walks backward as the blade pinches or twists.

  The saw suddenly lifts, jumps toward the operator, climbs out of the kerf, or Release the trigger and hold the saw motionless in the material until the blade completely FM-09

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

تعرض الصفحات العامة معاينة فقط. اشترِ الدليل الكامل لتنزيل خطوات الإصلاح الكاملة والمخططات وإجراءات التحقق.