FM-23: القطعة تنزلق أو تخرج من الحامل

FM-23

• Bit was not inserted straight or enough jaw length was not engaged
• Chuck was not tightened firmly by hand
• Bit shank is oily, undersized, worn, or damaged
• Chuck jaws or internal scroll are worn despite normal movement

1. A sound bit remains centered and retained through a moderate test, or chuck wear is proven.

1. Tighten the single-sleeve chuck firmly by hand using the spindle lock, then pull-test the bit before power.
2. Make one moderate controlled work test; if a sound correctly tightened bit still slips, route the chuck for service or supported replacement.
3. Release the trigger, remove the battery, and remove or catch the loose bit before it can fall.
4. Clean the bit shank and chuck jaws dry, reject a bent or damaged bit, and insert a sound bit straight with all three jaws centered.

هذه معاينة لإرشادات استكشاف الأخطاء وإصلاحها المشمولة في دليل الإصلاح الكامل.

• قطعة الحفر

• The chuck jaws open and close normally, but a straight compatible bit rotates or pulls out during moderate drilling or driving.

  The chuck jaws open and close normally, but a straight 1. Release the trigger, remove the battery, and remove or catch the loose bit before

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

تعرض الصفحات العامة معاينة فقط. اشترِ الدليل الكامل لتنزيل خطوات الإصلاح الكاملة والمخططات وإجراءات التحقق.