搜索维修指南

在知识库中查找维修指南、手册、症状和错误代码。

型号

手册

症状

With no fastener load, the bare or correctly fitted output sounds harsh, binds, knocks, or shakes abnormally.
Bezpieczne proste wiertło i czysta praca nie eliminują głośnego dźwięku lub drgań bez obciążenia.
The trigger returns normally and power drops, but the anvil repeatedly coasts instead of stopping promptly.
The motor can be heard, but the front output remains still in both directions with the bit removed.
WORKLIGHT COMES ON, BUT THE MOTOR WILL NOT START
The direction lever will not reach forward, reverse, or center lock, or the selected position does not hold.
锯片正常但锯发出磨擦、刮擦、敲击或强烈振动声
THE BATTERY WILL NOT SEAT, LATCH, RELEASE, OR STAY SECURE
The chuck jaws open and close normally, but a straight compatible bit rotates or pulls out during moderate drilling or driving.
La scie grince, claque, vibre ou vibre anormalement
钻机无法启动，尽管使用了充满电且已知良好的 BATTERY
A bit that appears clamped slips in use or visibly wobbles in a no-load test.
Pakiet battery nie wsuwa się, nie blokuje, nie zwalnia ani nie pozostaje bezpieczny w uchwycie.
The forward/reverse lever binds, commands the wrong direction, or center lock fails.
Блок не завершает зарядку или обеспечивает аномально короткое время работы при лёгкой нагрузке.
The drill sounds and rotates normally with no load, does not stall, overheat, slip, or vibrate abnormally, yet a corrected drilling or fastening task progresses much more slowly than expected.
The collar moves and holds a low numbered setting, but the clutch does not ratchet before a test fastener is overdriven in suitable scrap material.
With the battery removed and the chuck empty, turning the sleeve rotates the spindle and motor freely instead of providing enough lock to tighten or loosen the chuck by hand.
With the chuck stopped and battery removed, the top selector cannot be moved fully into range 1 or range 2, even after the chuck is turned by hand to align the gears.
The torque ring binds, will not hold a setting, or slips at clearly wrong torque.

故障模式

part