搜索维修指南

在知识库中查找维修指南、手册、症状和错误代码。

型号

手册

症状

Den kalla sågen startar, men stannar under ett kort tomgångstest eller lätt snitt innan värme byggs upp.
The cool tool starts, then stops during a brief no-load test or light fastening task before heat builds.
Starts, then stops while cool
The trigger returns normally and power drops, but the anvil repeatedly coasts instead of stopping promptly.
The motor can be heard, but the front output remains still in both directions with the bit removed.
The quick-release collar is stuck, has limited travel, or does not spring back after it is pulled.
Bladet lämnar linjen, böjs överdrivet, böjs eller går av under en annars kontrollerad skärning.
The drill stops early or gives far less runtime than expected without unusual heat.
The trigger lights the work area, but the motor stays silent and the quick-release chuck does not turn.
The drill or battery becomes rapidly or severely hot, or little cooling air can move through the tool vents.
The drill stalls, binds, shuts down, or has low power
The direction lever will not reach forward, reverse, or center lock, or the selected position does not hold.
The torque collar binds, will not stay on a setting, or the clutch slips or locks at every position.
THE BATTERY WILL NOT SEAT, LATCH, RELEASE, OR STAY SECURE
The drive operates normally, but the work light stays dark, flickers, or cuts in and out with trigger use.
After a normal full charge, the battery loses a large amount of indicated charge or usable low-load runtime while stored by itself in a cool, dry place.
锯子启动后负载下突然关闭
Chłodna wiertarka zaczyna działać, a następnie zatrzymuje się podczas krótkiego testu bez obciążenia lub lekkiej pracy.
Chuck clicks while tightening
BATTERY WILL NOT CHARGE

故障模式

part