斜切设置或 90 度切割精度错误

斜切杆无法锁定，象限设置移动，或指针为零时切割不方正。

• Bevel lever is not fully tightened
• Sawdust blocks the quadrant or shoe pivot
• Pointer or calibration stop is out of adjustment
• Shoe, quadrant, or pivot is bent from impact
• Blade or spindle runout is creating a false angle

1. The lever holds, the zero setting is square, and a scrap cut verifies the angle.

1. Remove the battery, set the bevel to zero, and place the saw on its blade side.
2. Brush the quadrant and pivot, then confirm the lever clamps firmly through the range.
3. Check blade-to-shoe squareness with a square and verify the kerf indicator on scrap.
4. If adjustment will not hold or structure is bent, stop and use qualified service.

这是完整维修手册中所含故障排除指南的预览。

• FM-13: Fm Dcs575 13

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

公开页面仅显示预览。购买完整手册以下载全部维修步骤、图示和验证流程。