model
DCB115
DeWalt DCB115係一款單埠鋰離子battery充電器，設計用於12V MAX、20V MAX同FLEXVOLT battery電池組。佢配備120 V交流輸入，適合北美市場，並有4 A單階段充電輸出。
报告的成功维修率 0%
型号详情
型号： DCB115
亦称： DeWalt, DeWalt Tools, DeWalt Power Tools, DCB115
症状
- The battery stops before the fully seated position and the charger cannot begin a normal charge. No visible charger crack, conductive debris, or swollen pack has yet been confirmed.
yet been confirmed. and the charger for cracked rails; use FM-17 or FM-18 if found.
- POWER CORD OR PLUG IS DAMAGED, LOOSE, SCORCHED, OR HOT
Stop using it and unplug by the plug only if the connection is safe to POWER CORD OR PLUG IS DAMAGED, LOOSE, Remove the battery, unplug the charger, and take it off the wall before correcting the mount.
- 充電器異常熱或濕，或有燒焦端子
斷開電源，讓充電器同電池組自然冷卻 充電器異常熱或濕，或有燒焦接點 唔好插入或充電損壞嘅電池組；只喺安全情況下移除。
- The red light keeps blinking while the yellow indicator stays on even after the battery and charger have naturally reached an allowed room-temperature environment.
The red light keeps blinking while the yellow indicator Remove the battery and let it reach normal room temperature naturally;
- Metal chips, grinding dust, steel wool, foil, or another dry conductive buildup is visible in the battery cavity, around contacts, or at ventilation slots. No liquid or active smoke, spark, burning, or melting is present.
Metal chips, grinding dust, steel wool, foil, or another dry 1. Unplug the charger and remove the battery before a conductive particle
- Liquid has entered the charger or battery interface, or the charger shows smoke, sparks, burning odor, charring, melting, or active electrical arcing.
Liquid has entered the charger or battery interface, or Warn other people away and disconnect power only from a safe
- 一個完全插好、物理狀況良好嘅兼容battery冇紅燈或黃燈，但同一部DCB115喺其他地方可以充電其他已證明正常嘅兼容電池組。
一個完全插好、物理正常嘅兼容battery冇紅燈或者黃燈，拔掉充電器，移除單一拒絕嘅電池組，檢查佢有冇熱、裂紋、膨脹、洩漏、濕潤、燒焦端子或者變形，若有就用FM-17。
- The attached cord or plug is cut, frayed, crushed, loose, discolored, scorched, or abnormally hot. There is no current smoke, spark, flame, melting charger housing, or liquid ingress.
The attached cord or plug is cut, frayed, crushed, loose, 1. Stop using the charger and unplug it by the plug only if the connection is
- A battery intended for the charger has physical damage, swelling, leakage, wetness, burned or melted terminals, or a deformed case. It may or may not still fit the charger.
A battery intended for the charger has physical damage, 1. Do not insert or recharge the damaged pack; if it is already in the
- The charger has dry visible structural damage to its upper or lower housing, tabletop feet, battery rails, retention area, contact support, or rear wall-mount slots. No liquid, smoke, spark, burning, or melting is active.
The charger has dry visible structural damage to its Unplug the charger and remove the battery before handling or flexing
- Independent checks show the battery charges and powers a tool normally, but the red or yellow indicator is too dim to read, remains stuck, stays on after pack removal, or does not match the label pattern.
Independent checks show the battery charges and Unplug the charger, remove the pack, and clean only the outside of the
- The charger housing becomes much hotter than normal charging warmth or operation repeatedly pauses as the charger heats, but there is no smoke, spark, burning odor, liquid, melting, swollen pack, or visible structural damage.
The charger housing becomes much hotter than normal Disconnect power, remove the battery, and let both complete items cool
故障模式
- FM-17: BATTERY裂開、膨脹、漏液、濕潤或者有燒焦端子
FM-17 BATTERY裂開、膨脹、漏液、濕潤或者有燒焦端子
- FM-03: BATTERY卡喺充電器入面或者唔能釋放
FM-03 BATTERY卡喺充電器入面或者唔能釋放
- FM-05: 一個兼容電池組冇燈，但其他電池組充電正常
FM-05 一個兼容電池組冇燈，但其他電池組充電正常
- FM-15: 導電碎屑喺 BATTERY 插槽或通風口內
FM-15 導電碎屑喺BATTERY腔體或通風口內
- FM-19: 牆壁安裝充電器有聲槽但會移位或脫落
FM-19 牆壁安裝充電器有聲槽但會移位或脫落
- FM-06: 電池包回到室溫後仍有熱/冷延遲
FM-06 電池包回到室溫後仍有熱/冷延遲
- FM-01: 插好電池組但冇指示燈或充電反應
FM-01 插好電池組但冇指示燈或者充電反應
- FM-02: BATTERY唔能夠完全滑入或插入充電器
FM-02 BATTERY唔能完全滑入或者插入充電器
- FM-16: 液體入咗，或者充電器冒煙、火花、燒焦或者熔化
FM-16 液體進入，或者充電器冒煙、火花、燃燒或者熔化
- FM-13: 插入充電器時斷路器或 GFCI 跳閘
FM-13 插入充電器會觸發斷路器或GFCI
- FM-11: 指示燈暗、卡住或者錯誤，但充電正常
FM-11 指示燈暗、卡住或者錯誤，但充電正常
- FM-04: BATTERY插好但唔能保持喺充電器入面固定
FM-04 BATTERY插好但唔能保持喺充電器入面固定
相关故障排除
Common symptoms
- The battery stops before the fully seated position and the charger cannot begin a normal charge. No visible charger crack, conductive debris, or swollen pack has yet been confirmed.
- POWER CORD OR PLUG IS DAMAGED, LOOSE, SCORCHED, OR HOT
- 充電器異常熱或濕，或有燒焦端子
- The red light keeps blinking while the yellow indicator stays on even after the battery and charger have naturally reached an allowed room-temperature environment.
- Metal chips, grinding dust, steel wool, foil, or another dry conductive buildup is visible in the battery cavity, around contacts, or at ventilation slots. No liquid or active smoke, spark, burning, or melting is present.
- Liquid has entered the charger or battery interface, or the charger shows smoke, sparks, burning odor, charring, melting, or active electrical arcing.
- 一個完全插好、物理狀況良好嘅兼容battery冇紅燈或黃燈，但同一部DCB115喺其他地方可以充電其他已證明正常嘅兼容電池組。
- The attached cord or plug is cut, frayed, crushed, loose, discolored, scorched, or abnormally hot. There is no current smoke, spark, flame, melting charger housing, or liquid ingress.
- A battery intended for the charger has physical damage, swelling, leakage, wetness, burned or melted terminals, or a deformed case. It may or may not still fit the charger.
- The charger has dry visible structural damage to its upper or lower housing, tabletop feet, battery rails, retention area, contact support, or rear wall-mount slots. No liquid, smoke, spark, burning, or melting is active.