Motor Tiếp Tục Chạy Sau Khi Thả Kích Hoạt

Âm thanh motor có nguồn và lưỡi cưa quay tiếp tục sau khi người vận hành thả hoàn toàn cò kích hoạt.

• Trigger is physically jammed by debris or housing damage
• Switch contacts or electronic control are stuck on
• Lock-off or trigger mechanism is broken or modified
• Liquid or internal damage has created uncommanded operation

1. The repaired saw turns off immediately at the motor command when the trigger is released and cannot start without deliberate lock-off operation.

1. Keep both hands controlling the saw, hold the shoe clear of people and loose material, and remove the battery only if it can be done without approaching th
2. Once power is removed, place the saw on its side in a clear area and do not reinstall any battery.
3. - Inspect only the external trigger and housing for obvious debris, cracks, liquid, scorching, or a control that does not return - do not open or lubricate th
4. Have the complete saw repaired by an authorized service center before any powered reuse. This is a terminal stop-use route. Use FM-14 as well for liquid, s

Đây là bản xem trước hướng dẫn khắc phục sự cố trong sách hướng dẫn sửa chữa đầy đủ.

• FM-09: Fm Dcs578 09

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

Trang công khai chỉ hiển thị bản xem trước. Mua hướng dẫn đầy đủ để tải toàn bộ các bước sửa chữa, sơ đồ và quy trình xác minh.