Motor Dừng Nhưng Phanh Điện Không Giảm Đà Lưỡi Cưa Như Trước

Âm thanh motor dừng khi thả cò, nhưng lưỡi cưa trượt đà lâu hơn nhiều so với trước khi dừng hẳn.

• Electric-brake control or motor feedback has failed
• Battery connection is intermittent during deceleration
• Blade, washer, or spindle condition is affecting coast behavior
• Expectation is based on an instant stop rather than a measurable change from normal operation

1. The product has an electric brake, but no owner procedure establishes an exact stop time. Always wait for a complete stop and guard closure regardless of brake behavior. Trigger release ends motor power and the repaired brake consistently shortens blade coast without noise, runout, or guard contact.

1. - Keep the shoe supported and hands on the handles until the blade stops completely and the lower guard closes - do not set the saw down during the coast.
2. Remove the battery and verify that the blade, clamp washer, screw, and lower guard are correctly assembled and free of visible damage or drag.
3. Fit a known-good fully charged compatible pack and make several clear no-load stop comparisons without contacting wood.
4. If the motor command ends but braking is consistently absent compared with the saw's established normal behavior, stop use and request authorized brake, mo

Đây là bản xem trước hướng dẫn khắc phục sự cố trong sách hướng dẫn sửa chữa đầy đủ.

• FM-10: Fm Dcs578 10

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

Trang công khai chỉ hiển thị bản xem trước. Mua hướng dẫn đầy đủ để tải toàn bộ các bước sửa chữa, sơ đồ và quy trình xác minh.