Lutningsvinkeln går inte att ställa in, låsa, hålla eller läsa korrekt

Sulan går inte att luta genom avsett område, lutningsspaken låser inte, vinkeln glider under snittet eller pekaren/kvadranten ger inte en upprepad vinkel.

• Sawdust is packed at the pivot, quadrant, pointer, or lever
• Lever is loose, stripped, cracked, or incorrectly positioned
• Shoe, pivot, quadrant, or pointer is bent or worn
• Zero calibration or angle reading is being confused with a general locking failure

1. The shoe sets within its range, locks firmly without movement, and produces a repeatable verified bevel angle.

1. Remove the battery and set the saw on a stable surface before touching the bevel lever or shoe.
2. Clean the exposed pivot, quadrant, pointer, and lever dry, then inspect for cracks, bend, missing hardware, or a lever that cannot clamp.
3. Loosen the lever counterclockwise, tilt the shoe to the desired marked angle within 0-57 degrees, and retighten the lever clockwise firmly.
4. - Check for movement by hand and confirm the angle with a gauge or a controlled scrap cut - use FM-21 only for a zero-degree calibration error.
5. If the shoe cannot move, lock, hold, or read repeatably, keep the saw out of service for authorized lever, pivot, quadrant, pointer, and shoe repair.

Det här är en förhandsgranskning av felsökningsvägledningen i den fullständiga reparationsmanualen.

• FM-22: Fm Dcs578 22

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

Offentliga sidor visar endast en förhandsgranskning. Köp den fullständiga manualen för att ladda ner alla reparationssteg, diagram och verifieringsprocedurer.