Klingans tomgångshastighet är låg, svajar eller slår av och på innan träet berörs

Med klingan fri från allt material går sågen ojämnt, ändrar hastighet upprepade gånger eller når inte sitt normala jämna tomgångsljud.

• Battery is weak, temperature-protected, loose, or making poor contact
• Blade or lower guard is rubbing because of incorrect assembly or damage
• Vents are blocked and the motor/electronics are overheating
• Trigger, electronic module, motor, bearings, or gear drive is failing

1. The blade accelerates promptly to a steady normal no-load sound and remains free of rub, surging, and intermittent power.

1. Release the trigger, wait for the blade to stop, remove the battery, and do not make a cut while no-load speed is unstable.
2. - Inspect the battery fit, contacts, blade clamp stack, guard clearance, and vents - correct dry debris, visible rub, or assembly error.
3. Hand-turn the blade with the battery removed to check for smooth free rotation without scraping, then install a known-good fully charged compatible pack.
4. Make one brief no-load run with the blade clear and listen for steady acceleration and speed.
5. If surging, intermittent power, or low no-load speed remains, stop use and route the saw for authorized switch, electronic, motor, bearing, and gear-drive

Det här är en förhandsgranskning av felsökningsvägledningen i den fullständiga reparationsmanualen.

• FM-11: Fm Dcs578 11

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

Offentliga sidor visar endast en förhandsgranskning. Köp den fullständiga manualen för att ladda ner alla reparationssteg, diagram och verifieringsprocedurer.