Viteza lamei sau forța de tăiere este sub normal

Lama se rotește, dar viteza sau forța de tăiere este sub normal într-o tăiere de lemn corect susținută.

• Battery charge or output is too low for the load
• Blade is dull, dirty, damaged, or unsuitable
• Blade rotation, size, arbor, or speed rating is incorrect
• Cut depth is excessive or feed pressure is too high
• Motor, bearing, or electronic drive fault

1. A clean supported test cut proceeds smoothly at normal blade speed.

1. Release the trigger, remove the battery, and inspect the installed blade.
2. Fit a clean sharp blade of the correct size, arbor, rotation, tooth count, and speed rating.
3. Set depth so about one-half tooth projects below the work and support the material near the cut.
4. - Test with a charged known-good pack and steady feed - if output stays low, seek service.

Aceasta este o previzualizare a ghidului de depanare inclus în manualul complet de reparație.

• FM-04: Fm Dcs575 04

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

Paginile publice afișează doar o previzualizare. Cumpără manualul complet pentru a descărca pașii completi de reparație, diagramele și procedurile de verificare.