A Serra Corta Devagar, Parece Fraca, Queima A Madeira Ou Deixa Um Corte Irregular

A lâmina alcança uma velocidade normal constante sem carga, mas o corte é incomumente lento, requer alimentação pesada, queima a madeira ou produz lascamento excessivo sem parada completa.

• Blade is dull, dirty, wrong tooth count, installed backward, or unsuitable for the wood
• Depth is excessive or bevel/depth levers are not secured
• Feed is too fast, material is wet/dense, or the shoe is not flat
• Battery capacity is low or internal drive drag appears only under load

1. A sharp correct blade makes a controlled cut at normal feed with no burning, excessive splintering, laboring, or unusual battery heat.

1. Release the trigger, wait for a full stop, remove the battery, and inspect the cut rather than increasing force.
2. - Verify blade type, tooth condition, rotation direction, clean clamp stack, and secure mounting - replace a dull, dirty, damaged, or unsuitable blade.
3. Set depth to about one-half tooth below the material, lock depth and bevel, support the work, keep the shoe flat, and use an unforced feed rate.
4. - Compare one cut using a known-good fully charged compatible pack - if normal no-load speed remains but cutting stays weak with a correct sharp blade and set

Esta é uma prévia da orientação de solução de problemas incluída no manual de reparo completo.

• FM-19: Fm Dcs578 19

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

As páginas públicas mostram apenas uma prévia. Compre o manual completo para baixar as etapas de reparo, diagramas e procedimentos de verificação completos.