A Luz De Trabalho Acende Mas O Motor E A Lâmina Não Ligam

Puxar o gatilho ativa a luz de trabalho, provando que algum controle de energia está presente, mas o motor está silencioso e a lâmina não gira.

• Blade lock is stuck engaged or spindle is mechanically jammed
• Lower guard, blade, or clamp stack is contacting another part
• Trigger switch output, electronic module, motor, or internal wiring has failed
• Battery can power the light but cannot supply motor current

1. The worklight and motor respond together and the blade accelerates smoothly with the blade clear of material.

1. After seeing the light-only response, release the trigger, remove the battery, and wait until every moving part is fully still.
2. Check that the blade lock button returns, the blade is clamped correctly, the lower guard moves freely, and no debris or part is visibly jamming the blade
3. Install a known-good fully charged compatible pack and make one clear no-load start attempt without touching the blade lock.
4. If the light still responds but the motor remains silent, stop use and have the switch, module, motor, spindle, and internal wiring diagnosed by authorized

Esta é uma prévia da orientação de solução de problemas incluída no manual de reparo completo.

• FM-08: Fm Dcs578 08

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

As páginas públicas mostram apenas uma prévia. Compre o manual completo para baixar as etapas de reparo, diagramas e procedimentos de verificação completos.