A Luz De Trabalho Falha, Pisca Ou Permanece Ligada Muito Além Do Seu Atraso Normal

O motor funciona normalmente, mas a luz de trabalho integrada não ilumina, pisca com um battery estável ou permanece acesa muito além do atraso normal após o gatilho.

• Worklight lens or opening is packed with sawdust
• Battery or trigger input is intermittent
• LED, light wiring, or electronic timing control has failed
• Normal delay of about 20 seconds is being mistaken for a fault

1. The worklight illuminates steadily with trigger operation and turns off automatically after its normal delay.

1. - Confirm the motor operates normally and time the light only after the trigger is fully released - a delay of about 20 seconds is normal.
2. Remove the battery and clean the light opening and surrounding external area with a dry brush or clean dry air.
3. Install a known-good fully charged compatible pack and repeat a brief no-load trigger-and-release check.
4. If the motor remains normal but the light still fails, flickers, or remains on abnormally, leave the housing closed and request authorized light or control

Esta é uma prévia da orientação de solução de problemas incluída no manual de reparo completo.

• FM-12: Fm Dcs578 12

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

As páginas públicas mostram apenas uma prévia. Compre o manual completo para baixar as etapas de reparo, diagramas e procedimentos de verificação completos.