De verstekhoek kan niet worden ingesteld, vergrendeld, vastgehouden of correct afgelezen

De zool kantelt niet door het beoogde bereik, de verstekhendel klemt niet, de hoek glijdt tijdens het zagen of de wijzer/kwadrant geeft geen herhaalbare hoek.

• Sawdust is packed at the pivot, quadrant, pointer, or lever
• Lever is loose, stripped, cracked, or incorrectly positioned
• Shoe, pivot, quadrant, or pointer is bent or worn
• Zero calibration or angle reading is being confused with a general locking failure

1. The shoe sets within its range, locks firmly without movement, and produces a repeatable verified bevel angle.

1. Remove the battery and set the saw on a stable surface before touching the bevel lever or shoe.
2. Clean the exposed pivot, quadrant, pointer, and lever dry, then inspect for cracks, bend, missing hardware, or a lever that cannot clamp.
3. Loosen the lever counterclockwise, tilt the shoe to the desired marked angle within 0-57 degrees, and retighten the lever clockwise firmly.
4. - Check for movement by hand and confirm the angle with a gauge or a controlled scrap cut - use FM-21 only for a zero-degree calibration error.
5. If the shoe cannot move, lock, hold, or read repeatably, keep the saw out of service for authorized lever, pivot, quadrant, pointer, and shoe repair.

Dit is een voorvertoning van de probleemoplossingsgids in de volledige reparatiehandleiding.

• FM-22: Fm Dcs578 22

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

Openbare pagina's tonen alleen een voorvertoning. Koop de volledige handleiding om complete reparatiestappen, diagrammen en verificatieprocedures te downloaden.