FM-06: STROOMVERLIES WANNEER HET GEREEDSCHAP OF BATTERY WORDT BEWEEGD

beweging-afhankelijke stroomuitval.

• Dry contamination, wear, or damage at the battery contacts
• Battery shell or latches allow electrical movement despite physical retention
• Tool contact block or internal wiring is loose
• Trigger, direction switch, brush, or motor connection is intermittent

1. Ordinary handling no longer interrupts power, or the internal intermittent path is conclusively routed to service.

1. Repeat with a known-good compatible battery to separate a pack-side intermittent condition from the tool-side path.
2. With the chuck empty, make one brief no-load test while changing only normal hand orientation; do not flex, strike, shim, or hold the pack in place.
3. If a proven battery still causes cutout with ordinary movement, remove it and route the contact block, wiring, switch, brush, or motor path to service.
4. Release the trigger and remove the battery before inspecting the contacts, latches, stem, and tool rail path for heat, burning, looseness, or impact damage.
5. Dry-clean the accessible contacts and latch surfaces, then install the original pack until the release latch pass an unpowered pull test.

Dit is een voorvertoning van de probleemoplossingsgids in de volledige reparatiehandleiding.

• De battery blijft fysiek vergrendeld, maar de motor, LED of beide vallen uit en komen terug wanneer het gereedschap of de battery wordt bewogen in normale werkoriëntatie.

  De battery blijft fysiek vergrendeld, maar de motor, LED, of 1. Laat de trekker los en verwijder de battery voordat u de contacten inspecteert,

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

Openbare pagina's tonen alleen een voorvertoning. Koop de volledige handleiding om complete reparatiestappen, diagrammen en verificatieprocedures te downloaden.