Den valgfrie støvporten passer ikke, forblir løs, tetter eller suger dårlig

Den valgfrie todelte støvporten kan ikke settes over den øvre beskyttelsen, vil ikke forbli

• Back half tab is not in the casting notch or halves are misaligned
• Two mounting screws are loose, missing, wrong, or the port is cracked

1. The port seats firmly with its tab and two screws, leaves all guards/adjustments free, stays clear, and carries visible dust into a working extractor during a test cut.

1. Remove the battery, fully loosen the depth lever, and remove any hose before inspecting the port.
2. Clear chips dry and align the back half over the upper guard with its locating tab fully in the casting notch, then align the front half.
3. Install and secure the two correct mounting screws, restore the depth setting, and confirm the port does not obstruct the guard, shoe, or adjustments.
4. - Connect a clear compatible hose to a proven vacuum and make one controlled scrap cut - replace a cracked or nonfitting port, and use authorized service if t

Dette er en forhåndsvisning av feilsøkingsveiledningen som er inkludert i den fullstendige reparasjonsmanualen.

• FM-28: Fm Dcs578 28

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

Offentlige sider viser bare en forhåndsvisning. Kjøp den fullstendige manualen for å laste ned fullstendige reparasjonstrinn, diagrammer og verifiseringsprosedyrer.