Bladlåsen eller klemmemekanismen lar ikke bladet fjernes eller sikres

Bladlåsen vil ikke engasjere eller frigjøre, klemmeklemmen screw vil ikke dreie riktig, eller screw og ytre skive kan ikke sikre et blad under installasjon.

• Blade lock button is jammed, damaged, or being used incorrectly
• Clamping screw threads, wrench flats, spindle, or outer washer are damaged
• Sawdust or corrosion is packed in the clamp area

1. The blade lock engages only during hand rotation, the correct screw turns in the proper direction, the washer seats correctly, and the blade clamps firmly.

1. Remove the battery, set the saw on its side, and never press the blade lock while the saw is powered or use it as a brake.
2. - Hand-turn the spindle while pressing the blade lock until it engages - use the blade wrench and remember the right-hand screw loosens counterclockwise and t
3. - Remove only the clamping screw and outer washer, clean sawdust dry, and inspect the lock, screw, washer, spindle threads, and wrench flats for damage - do n
4. Reassemble with the large flat face of the outer washer against the blade and the beveled side out, then tighten the screw firmly by the official sequence.
5. If the lock will not engage/release or any clamp or spindle surface is stripped, cracked, rounded, or unable to hold torque, keep the battery out and use a

Dette er en forhåndsvisning av feilsøkingsveiledningen som er inkludert i den fullstendige reparasjonsmanualen.

• FM-15: Fm Dcs578 15

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

Offentlige sider viser bare en forhåndsvisning. Kjøp den fullstendige manualen for å laste ned fullstendige reparasjonstrinn, diagrammer og verifiseringsprosedyrer.